{
    "ok": true,
    "doi": "10.46243/jst.2021.v6.i04.pp571-579",
    "references_in_record": 9,
    "not_read": [],
    "own_doi": [],
    "total": 4,
    "page": 1,
    "pages": 1,
    "per_page": 20,
    "items": [
        {
            "position": 1,
            "key": "ref1",
            "doi": "10.1155/2014/301271",
            "doi_url": "https://doi.org/10.1155/2014/301271",
            "unstructured": "Waluyo Adi Siswanto, An Alternate Method to Springback Compensation for Sheet Metal Forming, Volume 2014",
            "held": false
        },
        {
            "position": 6,
            "key": "ref6",
            "doi": "10.4273/ijvss.9.2.02",
            "doi_url": "https://doi.org/10.4273/ijvss.9.2.02",
            "unstructured": "Rajasekaran Mohan, Improvements in Vehicle Stiffness by Adding Internal Reinforcements. January 2017",
            "held": false
        },
        {
            "position": 7,
            "key": "ref7",
            "doi": "10.3390/met10020271",
            "doi_url": "https://doi.org/10.3390/met10020271",
            "unstructured": "Antonio Del Prete and Teresa Primo, Sheet Metal Forming Optimization Methodology for Servo Press Process Control Improvement, Published: 19 February 2020",
            "held": false
        },
        {
            "position": 9,
            "key": "ref9",
            "doi": "10.1016/j.jmatprotec.2016.03.027",
            "doi_url": "https://doi.org/10.1016/j.jmatprotec.2016.03.027",
            "unstructured": "Hela, Soussi, Masmoudi, Narjes, “Analysis of geometrical parameters and occurrence ofdefects in the hole-flanging process on thin sheet metal,” National EngineeringSchool of Sfax, University of Sfax, B.P. 1173, 3038. 26, Feb2016",
            "held": false
        }
    ]
}